Table of Contents
Advertisement
Syntax
Call the command without parameters:
no spanning-tree
Result
The spanning tree function is disabled.
Further notes
You enable the spanning tree function with the spanning-tree command.
You can display the status of this function and other information with the show spanning-
tree detailcommand.
You can display information about active ports with the show spanning-tree active
command.
7.3.3.3
spanning-tree compatibility
Description
With this command, you configure the compatibility version of the protocol that will be used by
the spanning tree function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree compatibility {stp|rst|mst}
The parameters have the following meaning:
Parameter
stp
rst
mst
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
The version is compatible with the Span‐
ning Tree protocol
The version is compatible with the Rap‐
ic Spanning Tree protocol
The version is compatible with the Mul‐
tiple Spanning Tree protocol
Network structures
7.3 Spanning Tree
Range of values / note
-
Default: enabled
-
311
Hide quick links:
Advertisement
Table of Contents
