Table of Contents
Advertisement
The parameter has the following meaning:
Parameter
Description
IPv6 address of the neighbor node
prefix
Keyword for a VLAN connection
vlan
Number of the addressed VLAN
vlan-id
Type or speed of the interface
interface-
type
Module no. and port no. of the interface
interface-id
Link layer address (MAC address) of the neighbor node
MAC ADDRESS
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The entry is configured.
Further notes
You delete an entry with the no ipv6 neighbor command.
You display the IPv6 neighbor table with the show ipv6 neighbors command.
8.2.3.2
no ipv6 neighbor
Description
With this command, you delete an entry from the IPv6 neighbor table.
Requirement
● The neighbor node is located on the same link.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ipv6 neighbor <prefix>
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
{vlan <vlan-id (1-4094)> | [<interface-type> <interface-id>]}
<MAC ADDRESS xx:xx:xx:xx:xx:xx>
Network protocols
8.2 IPv6 protocol
Range of values / note
Enter a valid IPv6 address.
-
1 ... 4094
Enter a valid interface.
xx:xx:xx:xx:xx:xx
363
Hide quick links:
Advertisement
Table of Contents
