Table of Contents
Advertisement
5.4.2.4
no wlan ipcf protocol-support (access point)
Note
This command is only available with the following KEY-PLUG:
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
With this command, you disable the optimized support of PROFINET or Ethernet/IP.
Requirement
The SCALANCE W700 device is in access point mode
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
no wlan ipcf protocol-support
Result
The optimized support of PROFINET or Ethernet/IP is disabled.
Further notes
You enable the optimized support of PROFINET or Ethernet/IP with the command.
You display the setting with the show wlan ipcf command.
5.4.2.5
wlan ipcf cycle-time (access point)
Note
This command is only available with the following KEY-PLUG:
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
With this command, you configure the cycle time for iPCF.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.4 iPCF
127
Hide quick links:
Advertisement
Table of Contents
