Network Protocols; Ipv4 Protocol; The "Show" Commands; Show Dcp Forwarding - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network protocols

This part contains the sections that describe the commands for working with the various

network protocols.

This section describes commands of the Internet Protocol (IP) version 4.

This section describes commands with which you display various settings.

This command shows an overview of the DCP forwarding behavior on one or all interfaces.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

cli> or cli#

Call up the command with the following parameters:

show dcp forwarding [port<interface-type><interface-id>]

The parameters have the following meaning:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Keyword for a an interface description

Type or speed of the interface

Module no. and port no. of the interface

Range of values / note

Enter a valid interface.

Show Quick Links

Table of Contents