Ip Name Server - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

The parameters have the following meaning:

learned-only

manually-only

The device uses the DNS servers specified in the configuration.

ip name server

This command specifies an IPv4 address or IPv6 address of a DNS server. If there is more

than one server, you can specify the order in which the servers are queried. To allow this, the

optional parameter index is available. The server with the lowest index is queried first.

You are in the Global Configuration mode.

The command prompt is as follows:

cli(config)#

Call up the command with the following parameters:

ip name-server {ipv4 <ucast_addr> | ipv6 <ip6_addr>} [index

<integer(1-3)>]

The parameters have the following meaning:

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

The device uses only the DNS servers as‐

signed by DHCP.

The device uses only the manually config‐

ured DNS servers. A maximum of three

DNS servers can be configured.

The device uses all available DNS serv‐

Keyword for IPv4

IPv4 address of the DNS server

Keyword for IPv6

IPv6 address of the DNS server

Keyword for the index

Index of the DNS server

Network protocols

8.1 IPv4 protocol

Range of values / note

Enter a valid IPv4 address.

Enter a valid IPv6 address.

Show Quick Links

Table of Contents