Table of Contents
Advertisement
5.7
iPRP
This section describes the commands relevant for working with iPRP (industrial Parallel
Redundancy Protocol).
Note
The commands are only available if the SCALANCE W700 device supports iPRP or the
function can be enabled.
● iPRP is enabled with the aid of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5 907-8PA00)
– W740 iFeatures (MLFB 6GK5 907-4PA00)
Note
Use of iPRP with other iFeatures
IPRP and other iFeatures (e.g. iPCF. iPCF-MC) are not compatible with each other and cannot
be used at the same time on a device.
iPRP with oversize frames (jumbo frames)
To be able to use oversize frames, oversize frames (jumbo frames) must be configured on all
devices in the network.
5.7.1
The "show" commands
This section describes commands with which you display various settings.
5.7.1.1
show wlan iprp information
Description
This command shows the configuration of "industrial Parallel Redundancy Protocol (iPRP)".
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show wlan iprp information
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.7 iPRP
147
Hide quick links:
Advertisement
Table of Contents
