Table of Contents
Advertisement
The parameters have the following meaning:
Parameter
standard
access-list-
number
Result
The access control list is deleted.
Further notes
You generate an IP access control list with the ip access-list command.
You display the configuration of the access control list with the show access-lists
command.
11.5.3
Commands in the Interface Configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
11.5.3.1
ip access-group
Description
With this command, you enable the access control of the packets of an interface.
Requirement
● An IP access list has been created.
● You are in the Interface configuration mode
.The command prompt is:
cli(config-if-$$$)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Specifies that a standard access control
list is generated
Number of the standard access control
list
Security and authentication
11.5 IP access control list
Range of values / note
-
1 ... 20
557
Hide quick links:
Advertisement
Table of Contents
