Table of Contents
Advertisement
Network structures
7.1 WLAN
Result
The channel is set.
Further notes
You display the setting with the show wlan ap <wlan 0/X> command.
7.1.5.25
wlan client mac mode (client)
Description
With this command, you specify how the MAC address is assigned to the client. This MAC
address is used by the client for communication with the access point.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan client mac mode { auto | manual | own | l2t }
The parameters have the following meaning:
Parameters
auto
manual
own
l2t
Result
The MAC address was assigned to the client.
230
Description
The client automatically adopts the source MAC address of the first frame that it
receives over the Ethernet interface. This parameter is set as default.
Enter the MAC address with the "wlan client manual mac" command.
The client uses the MAC address of the Ethernet interface for the WLAN interface.
The L2T parameter activates layer 2 tunneling. The client uses the MAC address of
the Ethernet interface for the WLAN interface. The network is also informed of the
MAC addresses connected to the Ethernet interface of the client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
