Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
Result
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder $$$ is replaced by the following name of the interface:
Type of interface
wlan
wds
vap
vlan
fast-ethernet
The placeholders $ or $-$ denote the numbering of the interface.
For the value ranges for the VLAN logical interface, refer to the upper table. You can only call
up interfaces that you created with the vlan command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface Configuration mode with the end or exit command.
You delete a logical interface with the no interface command.
You display the status and the configuration of the interfaces with the show interfaces
command.
4.1.10.6
no interface
Description
With this command, you delete a logical interface.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
<interface-type><interface-id>}
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Command prompt
cli(config-if-wlan-0-$)#
cli(config-if-wds$-0-$)#
cli(config-if-vap$-0-$)#
cli(config-if-vlan-$)#
cli(config-if-Fa-0-$)#
Configuration
4.1 System
Range of values / note
-
1 ... 4094
Enter a valid interface.
69
Hide quick links:
Advertisement
Table of Contents
