Switchport Priority Default; No Switchport Priority Default - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network structures

Further notes

You enable the filter with the switchport ingress-filter command.

You can display the status of the ingress filter and other settings with the show vlan port

config command.

switchport priority default

With this command, you configure the priority default for the interface.

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Call up the command with the following parameters:

switchport priority default <(0-7)>

The parameter has the following meaning:

The setting for the default priority of the interface is configured.

Further notes

You reset the priority default to the original default with the no switchport priority

default command.

You display this setting and other information with the show vlan port config command.

With this command, you reset the priority default for the interface to the default value.

Value for the priority default

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents