Table of Contents
Advertisement
Network structures
7.2 VLAN
7.2.2.4
no vlan
Description
With this command, you delete a VLAN on the device.
Requirement
● The VLAN must not be assigned to a physical port.
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameter:
no vlan <vlan-id(1-4094)>
Parameter
vlan-id
The VLAN with number 1 cannot be deleted.
Result
The VLAN is deleted
Further notes
With the vlan command, you create a VLAN on the device.
You can display information about the VLAN with the show vlan command.
7.2.2.5
base bridge-mode
Description
With this command, you configure whether or not the device is configured as a bridge according
to IEEE 802.1D for the Spanning Tree protocol or according to IEEE 802.1Q for a virtual bridged
LAN.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
288
Description
Number of the addressed VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
1 ... 4094
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
