Table of Contents
Advertisement
7.2.1
The "show" commands
This section describes commands with which you display various settings.
7.2.1.1
show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address <aa:aa:aa:aa:aa:aa>]
The parameters have the following meaning:
Parameter
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
[{interface <interface-type> <interface-id>}]
Description
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Network structures
7.2 VLAN
Range of values/note
-
Specify a valid MAC ad‐
dress.
-
Enter a valid interface.
279
Hide quick links:
Advertisement
Table of Contents
