Wds Connection Over (Access Point); Commands In The Force Roaming Configuration Mode; Introductory Sentence For The Force Roaming Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

wds connection over (access point)

With this command, you specify the VAP interface via which the WDS connection is

established.

This command is available only in access point mode.

You are in the Interface Configuration mode for the WDS interface.

The command prompt is as follows:

cli (config-if-wdsX-0-Y)#

Call up the command with the following parameters:

wds conncection over <vapX 0/Y>

The parameter has the following meaning:

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 29)".

The VAP interface is set.

Further notes

You display the setting with the show wlan wds <wdsX 0/Y> command.

this section describes commands that you can call up in the force roaming configuration mode.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Range of values / note

Enter a valid interface.

Network structures

Show Quick Links

Table of Contents