Table of Contents
Advertisement
10.1.3.4
no nat (Client)
Note
This command is only available in the client mode.
Description
With this command, you delete an entry from the translation list.
Note
This command is only available in the client mode
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
no nat {tcp|udp} <globalportfrom> [<globalportto>] <localip>
<localportfrom> [<localportto>]
The parameters have the following meaning:
Parameter
tcp
udp
globalportfrom
globalportto
localip
localportfrom
localportto
Result
The entry is deleted from the translation list.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Assignment of TCP for the follow‐
ing global port
Assignment of UDP for the follow‐
ing global port
Start port of the global port range
End port of the global port range
IPv4 address of the node in the lo‐
cal network
Start port of the local port range
End port of the local port range
Layer 3 functions
10.1 NAT
Range of values / note
-
-
enter the start port
enter the end port
enter a valid IPv4 address
enter the start port
enter the end port
461
Hide quick links:
Advertisement
Table of Contents
