Table of Contents
Advertisement
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dcp server
Result
The DCP server is disabled.
Further notes
You enable and configure the DCP server with the dcp server command.
8.1.2.9
ip domain lookup
Description
This command enables the DNS client of the device. To be able to use the function, a DNS
server must be reachable.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip domain lookup
Result
The DNS client of the device is enabled and when necessary sends queries to the DNS server.
8.1.2.10
no ip domain lookup
Description
This command disables the DNS client of the device.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network protocols
8.1 IPv4 protocol
351
Hide quick links:
Advertisement
Table of Contents
