Arp; The "Show" Commands; Show Ip Arp - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network protocols

8.10 ARP

This section describes commands of the Address Resolution Protocol (ARP).

This section describes commands with which you display various settings.

With this command, you display the IP ARP table.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

cli> or cli#

Call up the command with the following parameters:

show ip arp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>|

The parameters have the following meaning:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

If you do not select any parameter from the parameter list, the IP ARP table is displayed.

<ip-address>|<mac-address>|summary|information}]

Keyword for a VLAN connection

Number of the addressed VLAN

Type or speed of the interface

Module no. and port no. of the interface

Shows the IP addresses of the entries

in the ARP table

Shows the MAC addresses of the en‐

tries in the ARP table

Shows a summary of the entries in the

Displays information on the ARP config‐

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Enter a valid interface.

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents