Table of Contents
Advertisement
Security and authentication
11.3 WLAN
11.3.4
Commands in the security context configuration mode
This section describes commands that you can call up in the security context configuration
mode.
In the WLAN configuration mode, enter the wlan security context <ID (1-8)>
command to change to this mode.
● If you exit the security context configuration mode with the exit command, you return to
the WLAN configuration mode.
● If you exit the security context configuration mode with the end command, you return to
the Privileged EXEC mode.
11.3.4.1
wlan security authentication (client)
Description
With this command, you specify the type of authentication.
Note
This command is only available in the client mode.
Note
iPCF or iPCF-MC mode enabled
If iPCF or iPCF-MC mode is enabled, only "Open System" with the encryption method AES is
supported in the security settings.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call up the command with the following parameters:
wlan security authentication { show-methods | methods }
514
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
