Table of Contents
Advertisement
Layer 3 functions
10.1 NAT
10.1.1.3
show nat (Client)
Note
This command is only available in the client mode.
Description
This command shows the NAT configuration and the translation list.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show nat
Result
The configuration and the translation list are displayed.
See also
nat (Page 459)
nat local ip address (Client) (Page 462)
nat timeout (Client) (Page 468)
10.1.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
456
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
