Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
vap inter-ap-blocking allowed address {ipv4 <ucast_addr>} [resolver-
address {ipv4 <ucast_addr>}]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr IPv4 address
resolver-
address
ipv4
ucast_addr IPv4 address
If you do not configure address resolution, the management IPv4 address is used for resolution.
Result
The client can communicate with the SCALANCE W700 device whose IPv4 address was
specified as the parameter via the Ethernet interface.
Further notes
You display the IPv4 addresses with the show wlan inter-ap-blocking allowed
addresses command.
11.3.5.15
no vap inter-ap-blocking allowed address
Description
This command deletes the SCALANCE W700 device with the specified IP address from the
list of SCALANCE W700 devices with which clients are allowed to communicate.
Note
The command is only available when the following requirements are met:
● Access point mode
● The SCALANCE W700 device is equipped with one of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5907-8PA00)
– W700 Security (MLFB 6GK5907-0PA00)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Keyword for an IPv4 ad‐
dress
Address resolution
Keyword for an IPv4 ad‐
dress
Range of values / note
-
Enter a valid IPv4 address.
-
-
Enter the IPv4 address into which the permitted IPv4 ad‐
dress will be resolved.
Security and authentication
11.3 WLAN
539
Hide quick links:
Advertisement
Table of Contents
