Table of Contents
Advertisement
The parameters have the following meaning:
Parameters
show-types
index
antenna-index Antenna index
Result
The antenna type is specified.
7.1.5.17
wlan antenna mode
Description
With this command, you configure the settings for the antenna connected to the SCALANCE
W700 device.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna mode <index(1-2)> { RX | TX | RX-TX }
The parameters have the following meaning:
Parameter
index
RX
TX
RX-TX
Result
The use of the antenna is specified.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows a list of supported antennas
with the corresponding antenna index.
Antenna connector
Description
Antenna connector
For receiving only
For sending only
For sending and receiving
(default setting)
Network structures
Range of values / note
--
1...3
Enter the required antenna index.
You can obtain an overview of the anten‐
na indexes available on the on the SCA‐
LANCE W700 device with the wlan
antenna typ show-types command.
Range of values / note
1...2
--
--
--
7.1 WLAN
223
Hide quick links:
Advertisement
Table of Contents
