Vap Wds Id (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network structures

vap wds id (access point)

With this command, you set the WDS ID for the relevant VAP interface. To establish a WDS

connection, enter this WDS ID on the WDS partner.

This command is available only in access point mode.

You are in the Interface Configuration mode of the VAP interface.

The command prompt is as follows:

cli (config-if-vapX-0-Y)#

Call up the command with the following parameters:

vap wds-id <wds-id>

The parameter has the following meaning:

The WDS ID for the VAP interface is set.

WDS IDs longer than 32 characters are truncated at 32 characters.

Further notes

You display the setting with the show wlan vap <vap X 0/Y>command.

The WDS ID can be a maximum of 32 characters long.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents