Table of Contents
Advertisement
Network structures
7.1 WLAN
7.1.7.1
wds partner id-type (access point)
Description
With this command, you specify whether the WDS partner is detected by the access point by
the MAC address or the WDS ID.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds partner id-type { mac-address | wds-id }
The parameters have the following meaning:
Parameters
mac-address
wds-id
Result
The type of communication is specified.
Further notes
You display the setting with the show wlan wds <wdsX 0/Y> command.
See also
wds partner mac (access point) (Page 271)
wds partner wds-id (access point) (Page 272)
270
Description
The MAC address is used for communication. With the "wds partner mac"
command, you specify the MAC address.
The WDS ID is used for communication. With the "wds partner wds id" com‐
mand, you specify the WDS ID.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
