Table of Contents
Advertisement
Network protocols
8.3 DHCPv4 client (IPv4)
8.2.4.10
no ipv6 enable
Description
With this command, you disable IPv6 on the interface.
Requirement
You are in the Interface configuration mode of VLAN
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 enable
Result
IPv6 is disabled.
Further notes
You enable IPv6 with the ipv6 enable command.
You display this setting and other information with the show ipv6 interface command.
8.3
DHCPv4 client (IPv4)
This section describes commands of the Dynamic Host Configuration Protocol (DHCP).
8.3.1
The "show" commands
This section describes commands with which you display various settings.
8.3.1.1
show ip dhcp client stats
Description
With this command, you display the statistical counters of the DHCP client.
378
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
