Table of Contents
Advertisement
Network protocols
8.6 SNMP
Result
Write access for SNMPv1 and SNMPv2 PDUs is enabled.
Further notes
You block write access for SNMPv1 and SNMPv2 PDUs with the snmp v1-v2 readonly
command.
8.6.2.22
snmp user
Description
With this command, you configure the details of an SNMP user.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp user <UserName> [auth {md5|sha} <passwd> [priv DES <passwd>]]
The parameters have the following meaning:
Parameter
UserName
auth
passwd
priv DES
432
[{volatile|nonvolatile}]
Description
Name of the user
Specifies that authentication takes
place and which algorithm is used
Password for authentication
Specifies that there is encryption.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Range of values / note
max. 32 characters
● md5 (Message Digest 5)
● sha (Secure Hash Algorithm)
Default: No authentication
max. 32 characters
If you enter user passwords for
SNMPv3 via the CLI, you cannot
enter any special characters.
When using the WBM you can en‐
ter special characters in user pass‐
words for SNMPv3.
-
Default: No encryption
Hide quick links:
Advertisement
Table of Contents
