Table of Contents
Advertisement
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
no vap wds only
Result
You have specified who the VAP interface connects to.
Further notes
You display the setting with the show wlan vap <vap X 0/Y>command.
You enable the function with the vap wds only command.
See also
vap wds only (access point) (Page 268)
7.1.7
Commands in the WDS Interface Configuration mode
This section describes commands that you can call up in the WDS Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the interface wdsX 0/Y command to change to
this mode.
● If you exit the WDS Interface Configuration mode with the exit command, you return to
the Global Configuration mode.
● If you exit the WDS Interface Configuration mode with the end command, you return to the
Privileged EXEC mode.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.1 WLAN
269
Hide quick links:
Advertisement
Table of Contents
