Table of Contents
Advertisement
8.1.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
8.1.3.1
ip address
Description
With this command, you assign an IP address to a VLAN interface.
Requirement
● Interface is a router port
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>|/<prefix-length(1-32)>}
The parameters have the following meaning:
Parameter
ip-
address
subnet-
mask
prefix-
length
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
IP address for the VLAN interface
Subnet mask of the corresponding subnet
Decimal representation of the mask as a
number of "1" bits
Network protocols
Range of values / note
specify a valid IP address
enter a valid subnet mask
1 ... 32
8.1 IPv4 protocol
355
Hide quick links:
Advertisement
Table of Contents
