Link; No Link - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

12.1 Diagnostics

link

With this command, you configure and enable the monitoring of the physical network

connections for cable breaks or for pulling of the connector.

You are in the EVENTS Configuration mode.

The command prompt is as follows:

cli(config-events)#

Call up the command with the following parameters:

link {up|down}

The parameters have the following meaning:

The settings for monitoring the physical network connections have been configured.

Further notes

You can display the current setting with the show events faults config command.

You disable the function with the no link command.

With this command, you disable the monitoring of the physical network connections for cable

breaks or for pulling of the connector.

You are in the EVENTS Configuration mode.

The command prompt is as follows:

Only the establishment of a connection is signaled

Only a break on a connection is signaled

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents