Table of Contents
Advertisement
Parameter
primary
secondary
Result
The function of the device is specified.
Further notes
You disable the root bridge with the no spanning-tree mst instance-id root
command.
You display this setting and other information with the commands that start with show
spanning tree ....
7.3.3.11
no spanning-tree mst instance-id root
Description
With this command, you disable the "root bridge" function on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no spanning-tree mst{instance-id<instance-id(1-64)>}root
The parameters have the following meaning:
Parameter
instance-id
instance-id
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
The priority of the device is set to a low value so that the
device can become the root bridge (primary) of the Span‐
ning Tree instance. The lower the value, the higher the
priority.
The priority of the device is set to a low value so that the
device becomes the substitute root bridge (secondary) of
the Spanning Tree instance. If the root bridge (primary)
fails, the substitute root bridge (secondary) takes over the
task of the root bridge without delay.
Description
Keyword for the instance
Number of the instance
Network structures
7.3 Spanning Tree
Range of values / note
The priority is set to the val‐
ue 24576.
The priority is set to the val‐
ue 28672.
Range of values / note
-
1 ... 64
317
Hide quick links:
Advertisement
Table of Contents
