Commands In The Wlan Configuration Mode; Device Mode - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Further notes

You exit the particular WLAN Configuration mode with the end or exit command.

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.

In the Global Configuration mode, enter the wlan command to change to this mode.

Commands relating to other topics that can be called in the WLAN configuration mode can be

found in the relevant sections.

● If you exit the WLAN configuration mode with the exitcommand, you return to the Global

configuration mode.

● If you exit the WLAN Configuration mode with the end command, you return to the

Privileged EXEC mode.

With this command, you specify the mode of the SCALANCE W700 device.

You are in the WLAN Configuration mode.

The command prompt is as follows:

cli(config-wlan)#

Call up the command with the following parameters:

device mode { ap | client }

The parameters have the following meaning:

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Mode: Access Point mode (default setting)

Mode: Client mode

Network structures

Show Quick Links

Table of Contents