Table of Contents
Advertisement
Syntax
Call the command without parameter assignment:
wlan dhcp renew
Result
The function is enabled.
Further notes
You display the setting with the show wlan client <wlan 0/X> command.
You disable the function with the no wlan dhcp renew command.
7.1.5.42
no wlan dhcp renew (Client)
Description
Note
This command is only available in the client mode.
With this command, you disable the function. If the client changes to a different access point
the IPv4 address is not checked.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dhcp renew
Result
The function is disabled
Further notes
You enable the function with the wlan dhcp renew command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.1 WLAN
245
Hide quick links:
Advertisement
Table of Contents
