Table of Contents
Advertisement
Network structures
7.2 VLAN
The parameter has the following meaning:
Parameter
vlan-id
Result
The PVID is configured
Further notes
You can reset the setting to the default with the no switchport pvid command.
You configure the VLAN ID with the switchport access vlan command.
You display the setting and other information with the show vlan port config command.
7.2.3.9
no switchport pvid
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport pvid command.
You configure the VLAN ID with the switchport access vlan command.
296
Description
Number of the addressed VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
1 ... 4094
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
