Table of Contents
Advertisement
Security and authentication
11.3 WLAN
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameters:
vap inter-ap-blocking block non-ip-traffic
Result
There is no exchange of non-IP packets, for example layer 2 packets between the client and
the SCALANCE W700 devices configured on the access point as permitted communications
partners.
11.3.5.21
no vap inter-ap-blocking block non-ip-traffic
Description
This command allows the exchange of non-IP packets between the client and the SCALANCE
W700 devices that are configured on the access point as permitted communications partners.
Note
The command is only available when the following requirements are met:
● Access point mode
● The SCALANCE W700 device is equipped with one of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5907-8PA00)
– W700 Security (MLFB 6GK5907-0PA00)
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameters:
no vap inter-ap-blocking block non-ip-traffic
544
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
