Table of Contents
Advertisement
Result
The CLI session is ended and the Windows Login prompt is displayed.
4.1.8
ping
Description
With this command, you request a response from a device in the network.
This allows you to check whether or not another node is reachable.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
ping <destination-address>
The parameters have the following meaning:
Parameter
destination-
address
size
byte
count
packet_count
timeout
seconds
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If you do not select any parameters from the parameter list, the default values are used.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
[size<byte(0-2080)>]
[count<packet_count(1-10)>]
[timeout<seconds(1-100)>]
Description
Address of the called node
Keyword for the size of the packets to be
transferred
Keyword for the size of the packets in bytes 0 ... 2080
Keyword for the number of packets to be re‐
quested
Number of packets
Response wait time
If this time expires, the request is reported
as "timed out".
Time to the timeout in seconds
Configuration
4.1 System
Range of values/note
Enter a valid IPv4 address or a valid
host name.
-
-
1 ... 10
-
1 ... 100
63
Hide quick links:
Advertisement
Table of Contents
