Table of Contents
Advertisement
Result
The file is saved on the TFTP server.
4.2.3
load tftp
Description
With this command, you load the files from a TFTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
load tftp {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
[port <tcp port (1-65535)>] file <filename> filetype <filetype>
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
port
tcp port
file
filename
filetype
filetype
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Keyword for an IPv4 address
IPv4 unicast address of the TFTP server Enter a valid unicast IPv4 address.
Keyword for a domain name
Domain name (Fully Qualified Domain
Name) of the TFTP server
Keyword for an IPv6 address
IPv6 address of the TFTP server
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Keyword for a file name to be assigned -
Name of the file
Keyword for the file type to be loaded
Name of the file type
Note:
With certificate files only certificates
with a maximum of 8192 bits are sup‐
ported.
Configuration
4.2 Load and Save
Range of values / note
-
Maximum of 100 characters
-
Enter a valid unicast IPv6 address.
-
1 ... 65535
Maximum of 100 characters
-
Maximum of 100 characters
87
Hide quick links:
Advertisement
Table of Contents
