Commands In The Global Configuration Mode; Loadsave - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Configuration

4.2 Load and Save

For information on the file types , refer to this list (Page 82).

The file is loaded on the device from the TFTP server.

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.

In Privileged EXEC mode, enter the configure terminal command to change to this mode.

Commands relating to other topics that can be called in the Global configuration mode can be

found in the relevant sections.

You exit the Global configuration mode with the end or exit command and are then in the

Privileged EXEC mode again.

With this command, you change to the LOADSAVE configuration mode.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call the command without parameters:

You are now in the LOADSAVE configuration mode.

The command prompt is as follows:

cli(config-loadsave)#

Further notes

You exit the LOADSAVE configuration mode with the exit command.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents