Table of Contents
Advertisement
Configuration
4.2 Load and Save
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
Result
The file types are displayed or the file is copied.
Further notes
You configure the name of the file with the tftp filename command.
With the "show loadsave files" command, you can display the file types.
4.2.5.5
tftp server
Description
With this command, you configure the access to a TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp server {ipv4 <ucast-addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
[port <tcp port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4
ipv4-address
fqdn-name
FQDN
ipv6
ip6_addr
92
Description
Shows the available files
Keyword for a file type to be loaded
Name of the file type
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
Value for an IPv6 unicast address
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
-
max. 100 characters
Range of values / note
-
Enter a valid IPv4 unicast address.
-
Maximum 100 characters
-
Enter a valid IPv6 unicast address.
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
